2mm Real Carbon Fiber Twill top plate
1 - 22mm aluminum e-stop switch
1 - cable gland
2 - Spade Connectors (You can also solder the wire to the terminal)
2 - m4 bolts and 3d printed T-nuts for mounting
Wiring Instructions.
Please wire to NC / C (Top and Bottom pin) Center pin is NO
We have added an option to apply your own labeling in case you are not sure of mounting position yet
To apply label
1. Clean area with alcohol and let air dry
2. Carefully peel the decal off paper backing making sure all parts of the decal are on the transfer tape.
3. Use tweezer to carefully place the decal in the correct spot
4. Rub Decal to make sure its properly adhered to.
5. Slowly and Carefully pull back transfer tape.
<h5>Technical Specs</h5>
L-99mm x W-60mm x H-50mm
<br>
<p>uses 2 - m4 bolts with printed tnuts for mounting </p>
<br>
<iframe width="560" height="315" src="https://www.youtube.com/embed/f6Q9xMD_g1A" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen=""></iframe>
<p> </p>